pulse speed

This paper established a jet-pulse width alcohol, oil supply tension bar displacement, camshaft speed signals such as the model of relations.

由此本文建立起喷醇器脉冲宽度、供油拉杆位移量、凸轮轴转速等信号量的模型关系。

An electrical pulse in a wire travels close to the speed of light

电线里的电脉冲以接近光速的速度传输。

An electrical pulse in a wire travels close to the speed of light.

电线里的电脉冲以接近光速的速度传输。

Great temperature gradient brought the thermal stress in un-reacted solid particles, and natural convection and thermal pulse in the melted aluminum. When the thermal stress was higher than its maximum strength of the reactant, the reactant would be broken and the reaction speed was increased.

大的温度梯度在未反应固体内部产生热应力，当该热应力大于当时固体反应剂的极限强度时，会导致未反应固体的破裂，由此加速反应进程；

The collection and pre-process circuit of high-speed pulse signals based on the fixed frequency pulse filling in time interval method is designed to measure the time interval.

设计了基于固定频率脉冲填充法计数的高速脉冲信号采集及预处理电路，实现定时时间测量。

It points out that the speed does not bring about error when the phase difference between test pulse and exciting signal is 90 °.

认为在测量脉冲与激磁信号相位相差90°时，运动速度不会造成测量误差。

The large numbers of ambiguous TDOAs produced by pulse pairing, not only reduce the speed of processing, but also interfere the extraction of TDOA produced by other signals and pulse deinterleaving.

而脉冲配对产生的大量模糊时差，不仅降低了处理速度，还会干扰对其它信号的时差提取和信号分选处理。

Welding parameters such as angle of bending tip, pulse voltage, wire feed rate, pulse mode, size of groove and welding speed can affect the appearance of weld.

导电嘴弯曲角度、送丝速度、峰值电压、协同模式、焊接速度和坡口尺寸均会对窄间隙焊缝成形产生重要影响。

As a high-speed signal source for general test, Pulse/ Data Generator can generate dual-channel outputs of 3 types: pulse, burst and pattern.

脉冲/数据发生器作为一台高速的通用测试信号源，能够产生脉冲、群脉冲和数据三种类型的双通道信号输出。

Experimental result shows that under condition of isothermal layer channel, long distance and low target speed, target pulse-pulse echo correlation coefficient is about 0.7, for a stable time of about 10 s.

实验结果表明：在等温层信道中，目标距离较远、目标相对速度较低的情况下，海上目标回波脉间相关系数在70%左右，至少在10s内时间中，可以保持较强的相干性；